CPU Holders

CPU Holder CPU Holder CPU Holder

CPU Holders promote Maximum CPU Security and CPU safety. Of course, CPU holders save space, but CPU holders protect CPUs against theft and accidental damage. Our CPU Holders are for both Tower CPUs and Small Form Factor CPUs. SMARTdesks CPU holders allow easy access to ports and cable management. Our under desk CPU holders, are designed to hang in line with our C-Leg for Pi™ and HorizonLine™ Computer Tables.

CPU Holder

EZ Cinch straps any size CPU, large or small, to a heavy duty metal bracket.

This family of CPU holders is designed to hang the CPU in the negative space of our C-Leg. The leg helps protect the CPU from accidental damage from custodial maintenance. Knee space is maximized and risk of a collision is minimized. The CPU is suspended above the floor, and the user has full access to cables and drives.

The mounting bracket may also be used without the C-Leg, installing directly into the table top.

This mounting bracket is common to EZ-Cinch, The Brig and Li'l Brig CPU holders. Add your own lock or use a cable tie for added security. A wire clip is supplied to keep the mounting interlocked.

Maximum Security CPU Holder

The Brig CPU Holder gives users easy access to cable connections and drives. Unlike simple open shelves or J type holders, passers by can't pick up the CPU in two seconds and disappear.

Carbon steel bars fit closely to the sides, and flanges on front and rear pans contain the CPU, preventing removal from the CPU holder.

Download a pdf brochure.

Download pdf installation instructions

The position of the leg makes it impossible to remove the CPU from the rear, and flanges prevent the CPU from being removed through the front. The CPU is shown in the extreme position in an attempt to remove it from The Brig. The CPU would normally sit on the bottom pan, moved 3-4 inches forward. In its normal position, there is no obstruction to cable connections.

Maximum Security
Small Form Factor CPU Holder

Safe behind carbon steel bars, small form factor CPUs are confined to quarters. Sleek in-line design keeps CPU off the floor, away from hard knocks, protected by the C-Leg system of Pi™ and HorizonLine™ computer tables.

Use your own padlock or cable tie to interlock the Li'l Brig™ to the table. Have complete access to drives and cable connections.

Download a pdf brochure.

Download pdf installation instructions

The carbon steel bars permit no side-to-side movement. The front and rear flanges keep the CPU contained.

The in-line design keeps the CPU safe and out of the way.

The Li'l Brig CPU Holder gives you easy access to drives and cable connections, but the security to keep the CPU where it belongs.